Koneinsinöörikilta Alumumni


You are warmly welcome to 3D Printing & Additive Manufacturing workshop on Monday 4.6.2012, from 14.00 to 17.00 at ADDLAB - Aalto University Digital Design Laboratory. Address: Sähkömiehentie 4 G, Otaniemi Espoo For more detailed location info see http://addlab.aalto.fi/contact/.

Dr Jukka Tuomi the Chairman of FIRPA (Finnish Rapid Prototyping Association) will give us an introduction to latest developments in the area, then participants will work in facilitated group session.

The aim of the workshop is to enhance understanding of the future possibilities of 3D printing and additive manufacturing.We will work especially on the implications to business models, early R&D collaboration practices and supply chain management. How will this effect use of demos, prototypes and pilots? How to speed up product development etc.?

  • ADDLAB, Sähkömiehentie 4 G, Espoo
  • 4.6.2012 klo 14.00 - 17.00



  1. Toni Rumpunen


  1. Mikko Mattila
  2. Heikki Sjöman
  3. Ville Ristimäki


  1. Pia Tamminen
  2. Zhongbo Fan


  • Ei ilmoittautuneita.

© Koneinsinöörikilta ry

3D Printing & Additive Manufacturing

3D Printing & Additive Manufacturing